Table of Contents
Advertisement
3.3.3. IO Chipset Configure
Figure 3.5
OnBoard Floppy Controller
To set whether the built-in floppy controller is enabled. The default value is
"Enable".
Floppy Drive Swap
This item is used for exchanging the letter "A:" and "B:" of the two floppy
drives. In other words, for the two floppy drives, "A:" can be changed to "B:"
through this item, vice versa.
Floppy A (setting the floppy type)
The values to be set include:
None: Floppy drive not installed, please set as this item;
360K, 5.25in, capacity 360K;
1.2M, 5.25in, capacity 1.2MB;
720K, 3.5in, capacity 720K;
1.44M, 5.25in, capacity 1.44MB;
The default value of item is: 2.88M, 3.5in, capacity 2.88MB.
Serial Port 1 Address
To set the built-in serial port 1 (COM1 port). The options are: Disabled,
3F8/ IRQ4, 2F8/ IRQ3, 3E8/ IRQ4, 2E8/ IRQ3 and Auto. The default value is
"3F8/IRQ4".
Serial Port 1 Mode
If this mode is set as Normal 1, it will be used for the mouse and modem. If IR
device is available (IrDA), it is recommended this item be set as IrDA ADKIR.
22
Advertisement
Table of Contents
