Advertisement
Troubleshooting
error
light does not turn on:
detector triggers without reason - check detection area for potential
reason / light never turns off:
light flashes periodically /
detector doesn't reach
proper working condition:
triggers or blocks at mains
voltage peaks:
light turns off even if motion
is detected:
turns the light on during
daytime:
After mains connection: the detector takes approx. 1 min. to reach
a stable working condition!
cause/amendment
- twilight adjustment value too low
- connected lamp defective
- check mains power / fuses
causes of false triggering: draught,
heating, etc. may all provoke faulty
switching!
- detector is too sensitive, reduce the
detec-tion range sensitivity (by re-
mote control or manually) or cover
disturbing segments on the lens by
adhesive tape.
- check distances to lamps (heat re-
flection or direct light influence)
- connect RC element in parallel to
transformers, relais, electric ballast
- non-compensated fluorescent lamps
need an RC element or compensa-
tion condenser installed.
- install a Varistor between phase (L)
and neutral (N) wires
- increase the TIME value (to maxi-
mum if needed).
- twilight adjustment set too high (set
to a lower value). Respect 1 min.
start-up!
- detector is installed in the shade
- consider changing the location of
detector
9
Advertisement
