Advertisement
Warning!
- Any work on the main power supply must only be completed by trai-
ned specialists.
- The product must be installed in accordance with installation guideli-
nes/standards specific to your country.
- Disconnect the 230V power supply before starting the installation
process.
- As a precautionary measure, the power supply of the light should
always be fitted with a (250VAC, 10A) type C fuse in accordance
with EN60898-1.
- Faulty lamps may cause a short-circuit and thereby permanently
damage the device.
- Disconnect power prior to replacing a lamp.
- To ensure the operational reliability of the detector, keep a minimal
distance of 1m to lamps installed on the same height level.
- Lamps installed underneath the detector or in the detection area may
disturb the functionality. Keep detector away from heating devices.
- In case of malfunction, such as continuous lighting, or false triggering
please refer to the troubleshooting section on page 9.
Function
The detector reacts to the motion of heat (positive or negative in rela-
tion to the environment). If a person approaches the monitored area,
the device will turn on the connected light automatically. If the person
leaves the area, the light will be switched off after the preset duration
(short impulse, 10 sec. to 20 min.). The connected light will be turned
on only when the ambient light value is below the adjusted value.
Installation site
Install the device protected from weather conditions to maintain operation
reliability and product lifetime. Respect a minimum distance of 1 m to lights
fitted on the same height level. Lights mounted underneath the detector but
within the detection area may impair its function. Please check the trouble
shooting section for further details.
2
Advertisement
