Advertisement
Controls
LED, flashing once upon detection, three times upon adjusting TIME
or LUX values, or receiving a command from the remote control.
Attention! LUX or TIME value adjustments during a stable working
condition will be stored and become valid immediately. Any values
adjusted by remote control will be overridden. Either manual values or
values by remote control may be active, mixing is not possible
Standard/pet tolerance mode will be kept during adjustments. Device
control allows for pet tolerance stage 1 only (stage 2 with remote only).
SENS (sensitivity/range)
Detection range adjustment max = approx. 16 m frontal, 16 m lateral.
Should the detector be too sensitive (triggering without movement in
the detection range), the sensitivity/range can be reduced.
TIME
The timer determines for how long the lights will remain on following the
last movement in the detection area. Choices are between short
impulse (approx. 1 sec, approx. 20 sec. / 60 sec. break, selectable by
remote control only) and time delay (approx. 10 s to max. 20 min.). The
in-built Eco function will automatically reduce delay time to 3 minutes
even if set higher if a movement is detected for less than 30 seconds.
LUX (twilight sensor)
The twilight sensor regulates the operating threshold (light value) of the
detector determining when the device should be activated. Minimum
value 5 lux (moon symbol): The detector will turn on the light at night.
Maximum value 2000 lux (sun symbol): The detector will turn on the
light during daytime as well.
Recommendation: approx. 5 lux in staircases, 50 lux outdoors
Accessory:
maintenance remote
7
Advertisement
