Advertisement
Technical data
Nominal power:
Switching power:
Time adjustment:
Twilight switch:
IR remote control:
Detector head:
Detection area:
Detection range:
Rec. install. height:
Dimensions:
Temperature range:
IP protection:
* creep zone protection or pet tolerance function selectable. Tilting
the detector head (long range zone pointing towards the ground)
impairs pet tolerance function.
Electronic Control
Induction in long installation wires (if several detectors connected in parallel)
may generate a considerable capacitive current on the switched phase. For
electric loads using only a small control current, such as staircase timer
switches, this may lead to permanent switching or general malfunctions. In
order to minimise the capacitive current, an RC element may be connected in
parallel to the load. Alternatively, a contactor, which is more tolerant to
capacitive currents, may be installed before the load. We recommend a
maximum of four detectors connected in parallel.
Do not dispose of electrical appliances in your waste bin, use
the collecting point of your municipality, or return the old device
to your dealer.
10
230V ± 10 % / 50Hz
2000W / 8.7A max. (cos φ = 1)
1000VA / 4.35A max. inductive (cos φ = 0,5)
potential-free relay
short impulse approx. 1 sec. (with 20 or
60 sec. break)
approx. 10 sec. to 20 min.
5 to 2000 lux or lux memory (via remote ctrl)
AUTO / ON / OFF (4 to 6 m range)
pet tolerance function ON/OFF
rotatable ± 90° vertical; ± 90° horizontal
300°/240°/120° horizontal + 360° creep zone
protection*
16 m max. frontal, 16 m max. lateral, Ø 4 m
creep zone protection
2 to 5 m* (2.5 m recommended)
148 x 105 x 85 mm
-20 to +50 °C
IP 54, class II
Advertisement
