Connecting Multi Zone Jacks - Denon AVR-3805 Operating Instructions Manual

Connecting the antenna terminals
DIRECTION OF
BROADCASTING
AM LOOP
STATION
ANTENNA
(Supplied)
75 Ω/ohms
FM ANTENNA
COAXIAL
CABLE
AM OUTDOOR
ANTENNA
FM INDOOR
ANTENNA
GROUND
(Supplied)
• An F-type FM antenna cable plug can be connected
directly.
Notes:
• Do not connect two FM antennas simultaneously.
• Even if an external AM antenna is used, do not disconnect the AM loop antenna.
• Make sure AM loop antenna lead terminals do not touch metal parts of the panel.
Connecting the external input (EXT. IN) jacks
• These jacks are for inputting multi-channel audio signals from an outboard decoder, or a component with a
different type of multi-channel decoder, such as a DVD Audio player, a multi-channel SACD player, or other
future multi-channel sound format decoder.
• When making connections, also refer to the operating instructions of the other components.
Decoder with 8- or 6-channel
analog output
For instructions on playback using the external input (EXT. IN) jacks. (See page 36)
AM loop antenna assembly
Connect to the AM
antenna terminals.
1 2
3
Remove the vinyl tie
Bend in the reverse
and take out the
direction.
connection line.
4
a. With the
antenna on
top any
stable
Mount
surface.
b. With the
antenna
attached to
a wall.
Installation hole Mount on wall, etc.
Connection of AM antennas
1. Push the 2. Insert the 3. Return the
lever. conductor. lever.
R
L
R
L
R L
Connecting the MULTI ZONE jacks
For instructions on operations using the MULTI ZONE FUNCTIONS. (See pages 40, 41)
[1] ZONE2 preout CONNECTIONS
• If another power amplifier or pre-main (integrated) amplifier or is connected, the ZONE2 preout (variable/fixed
level) jacks can be used to play a different program source in ZONE2 the same time. (See page 41)
• The ZONE2 video out is only for the ZONE2.
Power amplifier
Extension jacks for future use.
CONTROL terminal
Perform the following operation before using an external controller connected to the RS--
232C terminal:
1. Press the ON/STANDBY button on the main unit and set the unit to the operating mode.
2. Perform the operation to turn off the power from the external control.
3. Check that the product has been set to the standby mode.
After checking the above, check the connections of the external controller. Operation is
possible.
[2] ZONE3 FIXEDOUT CONNECTIONS
• If another pre-main (integrated) amplifier is connected, the ZONE3 Fixed-OUT jacks can be used to play a
different program source in ZONE3 the same time. (See page 41)
Pre-main amplifier
B
R L
Extension jacks for future use.
ZONE2
INFRARED
RETRANSMITTER
INFRARED SENSOR
OUTPUT INPUT
AUX OUT
+ +
L
R
ZONE3
INFRARED
RETRANSMITTER
INFRARED SENSOR
OUTPUT INPUT
+ +
ENGLISH
AUX OUT
7