Setting Up The System - Denon AVR-3805 Operating Instructions Manual

Remote control unit
• For details on the functions of these parts, refer to the pages given in parentheses ( ).
Power buttons....................(31~36)
SYSTEM buttons ................(32, 41)
Mode selector
buttons ...................(11, 30, 32, 36)
Input source button ............(30, 36)
Surround mode
button .....................(30, 36, 38, 42)
SYSTEM buttons................(30~32)
SYSTEM SETUP
button .................................(11, 29)
ROOM EQ button.....................(16)
Tuner system
buttons ....................(31,34, 41, 50)
RDS button.........................(52~54)
VIDEO ON/OFF button .............(38)
INPUT MODE selector
buttons .....................................(36)
7

SETTING UP THE SYSTEM

• Once all connections with other AV components have been completed as described in "CONNECTIONS"
(see pages 5 to 9), make the various settings described below on the monitor screen using the AVR-3805's
Remote control signal
on-screen display function.
transmitter ................................(30)
These settings are required to set up the listening room's AV system centered around the AVR-3805.
Use the following buttons to set up the system
• Use the following buttons to set up the system.
1
Check that the remote control unit set to AMP mode.
10KEY/SYSTEM CALL
button.................................(30~35)
2
SURROUND PARAMETER button
...............................(42~45, 47, 48)
ON SCREEN button............(39, 45)
Cursor buttons..........................(11)
Master volume control
• System setup items and default values (set upon shipment from the factory)
buttons ...............................(37, 41)
1. Auto Setup/Room EQ
CH SELECT/
ENTER button...............(11, 41, 42)
1
MUTING button ........................(38) Auto Setup
SYSTEM buttons................(30~32)
Manual EQ
2
Setup
Room EQ
3
Setup
DIMMER button .......................(39)
SPEAKER button ......................(39)
Direct Mode
4
Setup
TEST TONE button ...................(41)
Mic Input
5
Select
SYSTEM SETUP button
Press this to display the system setup menu.
CURSOR buttons
Use these to move the cursors the left, right, up and
down on the screen
ENTER button
Press this to switch the display.
Also use this button to complete the setting.
Auto Setup/Room EQ
Set this to switch the surround
Power Amp
back channel's power amplifier
Assignment
for use for zone2 or zone3.
This parameter is for optimizing the Room EQ with
which the audio signals are produced from the
speakers.
Set the Room EQ setting with All or Assign for
each surround mode.
Set the ON/OFF setting of Room EQ, in the case of
the surround mode is in Direct or Pure Direct.
Set this to switch the Mic Input jack for use for Mic
or V.Aux L-channel input jack.
ENGLISH
Default settings
SURROUND BACK
All Channel and Frequency=0 dB
All
OFF
Mic
11