Connecting Wires To Terminals - Kenwood KDV-S211P Instruction Manual

Connecting Wires to Terminals

Digital output
Video output (Yellow)
Audio left output (White)
Audio right output (Red)
DVD Player back view
TV Monitor
(Optional Accessory)
Attaching Remote Control Sensor
1 Remove the backing paper from the Velcro tape on the
back of the Remote Control Sensor.
2 After wiping off the dirt or oil from the attachment location,
attach the Remote Control Sensor.
⁄
• Wipe off the dirt or oil from the surface to which the Sensor is
attached.
• Avoid locations under direct sunlight or near the TV monitor where
signals from the remote controller are not received easily.
• You can change the direction of the remote control sensor cable.
20
|
KDV-S211P
M4 X 5mm
Ground wire 7 (Black) - (To car chassis)
AV Cable 8
Power Cable 1
O T E
R E M
Battery
Remote Control Sensor 2
¤
• Connect the power cable 1 to the DVD player first, and
connect it to the cigarette lighter socket last. Connecting it
to the cigarette lighter socket first may blow the fuse.
Cigarette Lighter Plug
To Cigarette
Lighter Socket
Fuse (5A) built in
Semusu Screw 4
(M4 x 5 mm)
m m
M 4 X 5
Backing paper