Telephone operation
Handset operation
Volume control
While on a call, press
to increase the listening volume. You
six levels.
Call waiting
If you subscribe to call waiting service from your telephone service provider,
you hear 2 beeps if someone calls while you are already on a call. Press
FLASH to put your current call on hold and take the new call.
PHONE/
FLASH at any time to switch back and forth between calls.
Press
PHONE/
Mute
The mute function allows you to hear the other party, but the other party
cannot hear you.
Press MUTE/
DELETE
Handset locator
Use this feature to find misplaced handsets.
To start the paging tone:
HANDSET LOCATOR on the telephone base to start the paging
•
Press
/
tone on all handsets for 60 seconds.
NOTE: If you press
handset stops, but the paging to the rest of the handsets continues.
To stop the paging tone:
•
Press
PHONE/
on the handset(s).
-OR-
HANDSET LOCATOR on the telephone base.
•
Press
/
Join a call in progress
When a handset is already on a call and you would like to join the call, press
PHONE/
FLASH
OFF/
Press
CANCEL
end the call. The call does not end until all handsets hang up.
NOTE: You can use a maximum of 4 system handsets at the same time on an outside call.
/VOLUME to decrease or press
qCID
while on a call to enable or disable the mute feature.
OFF/
CANCEL
,
/SPEA�ER
SPEA�ER, or any dialing key (0-9, TONE , or #)
FLASH
/SPEA�ER
SPEA�ER on your handset.
or
or place the handset in the telephone base or charger to
can set the listening volume to one of
or MUTE/
on a handset, the ringer of that
DELETE
11
/VOLUME
pDIR