Telephone Base And Charger Installation - AT&T CL82311 User Manual

Getting started

Telephone base and charger installation

Install the telephone base and charger as shown below.
Telephone base installation
•
Plug the other end
of the telephone
line cord into a
telephone jack or
a DSL filter.
•
Raise the antenna.
Charger installation
IMPORTANT INFORMATION
1. Use only the power adapter(s) supplied with this product. To order a replacement
power adapter, visit our website at
1 (800) 222-3111
For more detailed instructions, refer to the online Complete user's manual at
www.telephones.att.com/manuals.
2. The power adapters are intended to be correctly oriented in a vertical or floor
mount position. The prongs are not designed to hold the plug in place if it is
plugged into a ceiling, under-the-table or cabinet outlet.
Telephone line cord
•
If you have DSL high-speed
Internet service, a DSL filter
(not included) is required.
The DSL filter must be
plugged into the telephone
wall jack.
•
www.telephones.att.com
1 (866) 288-4268
. In Canada, dial
3
•
•
•
•
Plug the power
adapter into a power
outlet not controlled
by a wall switch.
Plug one end of the
telephone line cord
into the telephone
jack on the back of
the telephone base.
Plug the small end of
the telephone base
power adapter into
the power adapter
jack on the back of
the telephone base.
Route the power
adapter cord and the
telephone line cord
through this slot.
Plug the large end
of the power adapter
into a power outlet
not controlled by a
wall switch.
or call
.