Battery Installation And Charging - AT&T CL82311 User Manual

Getting started

Battery installation and charging

Once you have installed the battery, the screen indicates the battery status
(see the table below). For best performance, keep the handset in the
telephone base or charger when not in use. The battery is fully charged
after 10 hours of continuous charging.
specifications section on page 43 for battery operating times.
Battery indicators
The screen is blank, or
shows Place in charger
and (flashing).
The screen shows
Low battery and
(flashing).
The screen shows
HANDSET X.
Step 1
Plug the battery
connector securely
into the socket inside
the handset battery
compartment. Insert the
supplied battery with
the label THIS SIDE UP
facing up as indicated.
CHARGE light
Battery status
Battery has no or
very little charge. The
handset cannot be used.
Battery has enough
charge to be used for a
short time.
Battery is charged.
Step 3
Charge the handset by placing it face forward in the
telephone base or charger. The CHARGE light on the
top of the handset is on during charging.
IMPORTANT INFORMATION
1. Use only the supplied rechargeable battery or
replacement battery (model BT166342).
our website at
1 (800) 222-3111
1 (866) 288-4268
refer to the online Complete user's manual at
www.telephones.att.com/manuals.
2. If you do not use the handset for a long time, disconnect
and remove the battery to prevent possible leakage.
See the table in the Technical
Action
Charge without interruption
(at least 30 minutes).
Charge without interruption
(at least 30 minutes).
To keep the battery charged, place it in the
telephone base or charger when not in use.
Step 2
Align the cover flat against
the battery compartment,
then slide it upwards until
it clicks into place.
www.telephones.att.com
. In Canada, dial
.
For more detailed instructions,
4
To order, visit
or call