Step 6 – Arming Capture; Step 7 – Checking Capture - Cuddeback Capture Operating Instructions Manual

STEP 6 – Arming Capture
1. You must arm Capture before it will record any images. Turn the
Rotary Switch to one of the 5 ARMED settings.
2. These settings represent the amount of time Capture will idle after
taking a picture before it will rearm itself to be ready for the
next picture.
a. 30 Seconds – game trails
b. 1 Minute – scrapes
c. 5 Minutes – food plots and feed stations
3. When Capture is initially armed, the delay
setting will be displayed on the LCD.
4. After 5 seconds, a countdown will be
displayed, starting at 40 and counting down
toward 0. When this counter reaches 0,
Capture is armed. This gives you time to
leave the area without triggering an image.
5. After an image is taken, Capture will display a
Countdown timer that represents your
armed setting. This allows you to determine
if the Capture is armed and how long before
it will be rearmed if it is idle.
STEP 7 – Checking Capture
To retrieve Capture images
1. Loosen the thumb screw (and remove padlock if installed).
2. Open the cover (numbers may or may not be displayed on the LCD).
3. Press the A key.
4. The number of images saved will be displayed on the LCD.
5. Wait until the green LED goes off before removing the SD card!
d. 15 Minutes – feed stations
e. 30 Minutes – feed stations
Delay setting is displayed
Countdown is displayed
Countdown timer