Connecting Your Equipment; Connecting Your Equipments; (Xn-P02, Xn-P02Dab Only); Stereo Receiver: Sx-P01, Sx-P01Dab - Pioneer N-P01-S Operating Instructions Manual

10
10
Connecting your equipment (Stereo receiver: SX-P01, SX-P01DAB)
Connecting your equipments (XN-P02, XN-P02DAB only)
Before making or changing the connections, turn off the power and disconnect the power cord from the AC outlet.
Monaural mini-plug
cord (without resistor)
To CONTROL OUT
Pioneer component
Antenna connection
Supplied FM wire antenna (SX-P01), DAB/FM wire
antenna (SX-P01DAB):
Connect the supplied FM wire antenna or DAB/FM wire
antenna to the FM socket or DAB/FM socket, and position the
wire antenna in the direction where the strongest signal can
be received.
External FM wire antenna:
Use an external FM wire antenna (75 ohms coaxial cable) for
better reception. When an external FM wire antenna is used,
disconnect the supplied FM wire antenna.
Note
• Placing the wire antenna on the unit or near the AC power
lead may cause noise pickup. Place the wire antenna away
from the unit for better reception.
42
Right speaker
SX-P01
ANTENNA
socket of other
FM wire antenna
Speaker connection
Use speakers with an impedance of 4 ohms as lower
impedance speakers can damage the unit.
1 Loosen the knobs of the speaker output terminals.
2 Insert the speaker cable wires into each of the terminal
post holes (positive (+) cable to the red knob, and
negative (–) cable to the black knob), then tighten the
knobs.
3
Connect the other ends of the cables to the terminals of
speakers (make sure the positive and negative (+/–)
terminals on the speakers match those on the stereo
receiver).
SX-P01DAB: Connect
the DAB/FM wire
antenna to the DAB/
FM socket.
Left speaker
AC IN
Wall socket (AC 220 V to
230 V, 50 Hz)
CAUTION
• These speaker terminals carry HAZARDOUS LIVE voltage.
To prevent the risk of electric shock when connecting or
disconnecting the speaker cables, disconnect the power
cord before touching any uninsulated parts.
• Do not mistake the right and the left channels. The right
speaker is the one on the right side when you face the unit.
• Do not let the bare speaker wires touch each other.
• Make sure that all the bare speaker wire is twisted together
and inserted fully into the speaker terminal. If any of the
bare speaker wire touches the back panel, it may cause the
power to cut off as a safety measure.