Playing Your Ipod/Iphone/Ipad - Pioneer N-P01-S Operating Instructions Manual

4
4
2
Set up to stand the iPod/iPhone/iPad.
When using an iPod/iPhone
Make sure the iPod/iPhone cable is aligned along the groove
for it on the back of the stand that comes with the unit.
When using iPad
Make sure to place the iPad in a horizontal direction on the
stand.
16

Playing your iPod/iPhone/iPad

CAUTION
• When your iPod/iPhone/iPad is connected to this player
and you wish to operate the iPod/iPhone/iPad directly, be
sure to hold the iPod/iPhone/iPad steady with the other
Back of stand
hand to prevent malfunctions due to faulty contacts.
1
Connect your iPod/iPhone/iPad.
To connect your iPod/iPhone/iPad, see Connect iPod/
iPhone/iPad to the USB terminal on page 15.
2 Press iPod/USB to select iPod/USB as the input source.
iPod/USB is shown on the display and starts playback.
Note
• When the iPod/iPhone/iPad is connected to this player, the
playback information for the songs are displayed on the
iPod/iPhone/iPad display. Pressing iPod CONTROL
iPod/iPhone
cable
button on the remote will switch the display and display the
information on the front panel of the player.
Important
• If this player cannot play your iPod/iPhone/iPad, perform
the following troubleshooting checks:
- Check whether the iPod/iPhone/iPad is supported by this
player (page 15).
Reconnect the iPod/iPhone/iPad to the player. If this
-
doesn't seem to work, try resetting your iPod/iPhone/
iPad.
- Check the iPod/iPhone/iPad software is supported by this
player.
• If the iPod/iPhone/iPad cannot be operated, check the
following items:
Is the iPod/iPhone/iPad connected correctly? Reconnect
-
the iPod/iPhone/iPad to the player.
Is the iPod/iPhone/iPad experiencing a hangup? Try
-
resetting the iPod/iPhone/iPad, and reconnect it to the
player.
When connecting the iPad, use only an iPad dedicated
-
cable.
iPod/iPhone/iPad playback (Network audio player: N-P01)
Tip
• iPod/iPhone/iPad recharging occurs whenever an iPod/
iPhone/iPad is connected to this player. (This function is
only supported when the power is initially turned on or
during Network Standby).
• When input is switched from iPod/USB to another
function, iPod/iPhone/iPad playback is temporarily
stopped.