Replacing The Grass Deflector - Toro GrandStand 74534TE Operator's Manual

1. 10-1/8 inch (25.7 cm) for
102 cm mower decks and
11-1/8 inch (28.2 cm) for
91 cm mower decks
2. Spring jam nut

Replacing the Grass Deflector

WARNING
An uncovered discharge opening could allow the
lawn mower to throw objects in the operator's or
bystander's direction and result in serious injury.
Also, contact with the blade could occur.
Never operate the lawn mower unless you install a
cover plate, a mulch plate, grass deflector or bagger.
1. Remove the locknut, bolt, spring and spacer holding
the deflector to the pivot brackets (Figure 90).
Remove damaged or worn grass deflector.
1
4 3
Figure 89
3. Front nut
4. Compression spring
1
2
g015594
1. Bolt
2. Spacer
g012783
3. Locknut
4. Spring
2. Place the spacer and spring onto grass deflector.
Place one J end of the spring behind the deck edge.
Note: Make sure one J end of the spring is installed
behind the deck edge before installing the bolt as
shown in Figure 90.
3. Install the bolt and nut. Place one J hook end of the
spring around the grass deflector (Figure 90).
Important: The grass deflector must be able
to rotate. Lift the deflector up to the full open
position and ensure that it rotates into the full
down position.
60
6 2
Figure 90
5. Spring installed
6. Grass Deflector
7. J hook end of spring
4
7
3
5