Controls System Maintenance; Adjusting The Motion Control Handle Positions - Toro GrandStand 74534TE Operator's Manual

Figure 68
1. Hydraulic pumps
2. Idler pulley
3. Clutch pulley
8. Lower the machine to the operating position.
Refer to PreMaintenance at the beginning of the
Maintenance Section.
9. Install the mower deck belt to the clutch on 30in
mower decks or install the left mower belt install the
clutch for 40in mower decks. Refer to Replacing the
Mower Deck Belts.
4. Clutch retainer
5. Pump drive belt
6. Pump drive pulley
Controls System
Maintenance
Adjusting the Motion Control
Handle Positions
Adjusting the Right Side Motion Control
Lever
If the motion control levers do not align horizontally,
adjust the right side motion control lever.
Note: Adjust the horizontal alignment before the front
to back alignment.
1. Disengage the PTO, move the right side motion
control lever to the neutral position and set the
parking brake.
2. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Push the right motion control lever down out of
locked neutral position (Figure 69).
4. Check if it aligns horizontally with the left motion
control lever (Figure 69).
1. Left motion control lever
2. Right motion control lever
in neutral locked position
5. To adjust the right motion control lever horizontally,
the cam needs to be adjusted.
6. Remove the cushion from the rear of the machine.
7. Loosen the nut holding the cam (Figure 70).
8. Adjust the cam until the right motion control lever
aligns with the left motion control lever and tighten
the nut and bolt for the cam.
49
Figure 69
3. Check the horizontal
alignment here
4. Right motion control lever