Model Select; Model Name Entry - JR Racing XR3i Quick Start Setup

4680 JR XR3i manual 7/17/02

Model Select

(System Mode)
The XR3i has memory for four models. This feature allows
for four different models to be operated with the same trans-
mitter (additional receivers and servos must be purchased
separately) or one model with four different race setups.
mdl
Accessing the Model Select Function
Press and hold the
Scroll and Channel keys
at the same time while
turning transmitter
power switch on.
Press the Increase
or Decrease keys to
select the desired
model to be used
(1, 2, 3, or 4).
1. Press the Scroll and Channel keys at the same time
and hold.
2. Turn the transmitter power switch on to enter System
mode.
3. If "MDL" does not appear on the screen, press the Scroll
key until "MDL" appears.
4. Press the Increase or Decrease keys to select the desired
model number (1, 2, 3, or 4).
5. Press the Scroll key to access the Model Name Entry
function.
6. To exit System mode, either turn the transmitter power
switch off or press the Scroll and Channel keys at the
same time.
14
12:14 PM Page 14
Model Select
Fuction
1 Current Model
Number
ENTER
SCROLL CHANNEL
CLEAR
INCREASE DECREASE

Model Name Entry

(System Mode)
The XR3i allows a three-character name to be input for
each of the four models available. The current model with
name will then be displayed in the Normal display screen.
This feature is useful to help identify different models,
setups, etc.
md !
1
Accessing the Model Name
Entry Function
Press and hold the Scroll
and Channel keys at the
same time while turning
transmitter power switch
SCROLL
on. Next, press the Scroll
key until the flashing
"M" appears.
Press the Increase or
Decrease keys to
select the correct
INCREASE
letter/number to be used.
1. Press the Scroll and Channel keys at the same time
and hold.
2. Turn on the transmitter power switch to enter the
System mode.
3. Press the Scroll key until "MD1" appears on the screen
with the first character flashing.
4. Press the Increase or Decrease keys to select the correct
letter/number for the first character (flashing). To clear the
character, pressing the Increase and Decrease keys at the
same time.
5. To change the remaining two characters, press the
Channel key until the desired character to be changed
is flashing.
6. Press the Scroll key to access the Frame Rate function.
7. To exit the System mode, either turn the transmitter power
switch off or press the Scroll and Channel keys at the
same time.
Character to
be Adjusted
Current Model
Number
Press the Channel
key to select the
character to be
ENTER
changed.
CHANNEL
CLEAR
DECREASE