Inputs - Datalogic DX8200A Reference Manual

INSTALLATION

Inputs

The inputs of the reader are on the 26-pin connector of the DX8200A.
These inputs are called EXT_TRIG/PS, IN2/ENC, IN3 and IN4.
Pin Name
18 EXT_TRIG/PS A External trigger (polarity insensitive) for PS
19 EXT_TRIG/PS B External trigger (polarity insensitive) for PS
6 IN2/ENC A
10 IN2/ENC B
14 IN3A
15 IN4A
24 IN_REF
IN2/ENC is normally used for the Encoder input. In PackTrack™ mode, it detects the
conveyor speed. The maximum Encoder frequency is 2 KHz.
EXT_TRIG/PS is the main presence sensor. When active, this input tells the scanner to scan
for a code and that decoding can take place. The yellow LED (Figure C, 3) indicates the
EXT_TRIG/PS is active.
IN3 and IN4 can be used as the stop signal for the reading phase.
All inputs are optocoupled, polarity insensitive, and driven by a constant current generator;
the command signal is filtered through an anti-disturbance circuit which generates a delay
which can be set to 5 ms or 500 µ s. In particular, EXT_TRIG/PS, IN3 and IN4 share the
same value which usually corresponds to 5 ms when using a photoelectric sensor, while IN2
has a different value which is set to 500 µ s when this input is used for the Encoder.
Figure 8 – PNP Command Input Connection using External Power
+ 5V
Figure 9 - PNP Command Input Connection using Scanner Power
Function
Input signal 2 (polarity insensitive) for Encoder
Input signal 2 (polarity insensitive) for Encoder
Input signal 3 (polarity insensitive)
Input signal 4 (polarity insensitive)
Common reference of IN3 and IN4 (polarity insensitive)
DX8200A
A/B
+ 5V
~
-
+
~
B/A
DX8200A
VS
A/B
~
-
+
~
B/A
GND
Vext
EXTERNAL TRIGGER/ENCODER
V
Ground
EXTERNAL TRIGGER/ENCODER
V
Ground
2
13