Figure 7: Stand-Alone Connection Setup - SMC Networks WiShare SMCWTVA100 User Manual

Using an Ethernet cable can increase your device's Internet speed as
N :
OTE
compared to the "Bridge to Wireless" mode..
To use your SMCWTVA100 without an Internet connection (no
■
bridge, see Figure 7 on page
setting). Click Apply and no further steps are necessary.
You are now ready to use the SMCWTVA100 in the Virtual AP
(stand-alone) configuration. Go to
for procedures on how to screencast.

Figure 7: Stand-Alone Connection Setup

(Note: Bridge to Wireless only as shown in
7.
Click the "Scan AP" button and click to select the 802.11 wireless
access point that you would like to bridge the internet from.
The SMCWTVA100 will restart and connect to the wireless AP that you
selected, giving you both screencast and Internet connectivity. No
further steps are necessary you are now ready to use the
SMCWTVA100 in the Bridge to Wireless configuration. Go to
Modes" on page 45
– 24 –
C
Connect a Device to the SMCWTVA100
24), select "Virtual AP only" (default
"Operation Modes" on page 45
for procedures on how to screencast.
| Installation Guide
3
HAPTER
Figure 8)
"Operation