Connecting Wires To Terminals - Kenwood KDC-MP3035 Instruction Manual

Connecting Wires to Terminals

To connect these leads, refer to the relevant
instruction manuals.
To Kenwood disc changer/
External optional accessory
Fuse (10A)
Wiring harness
(Accessory1)
Power control wire (Blue/White)
Motor antenna control wire (Blue)
TEL mute wire (Brown)
FRONT L
FRONT R
REAR L
REAR R
Ignition wire (Red)
Battery wire (Yellow)
Ground wire (Black) - (To car chassis)
Sub Woofer left output (White) (KDC-MP3035)
Sub Woofer right output (Red) (KDC-MP3035)
Rear left output/Sub Woofer left output (White) (KDC-MP335)
Rear right output/Sub Woofer right output (Red) (KDC-MP335)
If no connections are made, do not let the wire come out from the tab.
When using the optional power amplifier, connect to its power
control terminal.
P.CONT
Depending on what antenna you are using, connect either to the
control terminal of the motor antenna, or to the power terminal
ANT CONT
for the booster amplifier of the film-type antenna.
Connect to the terminal that is grounded when either the
MUTE
telephone rings or during conversation.
White
White/Black
Gray
Gray/Black
Green
Green/Black
Purple
Purple/Black
Car fuse
box
ACC
Rear left output (White) (KDC-MP3035)
REAR
Rear right output (Red) (KDC-MP3035)
Front left output (White)
FRONT
Front right output (Red)
FM/AM antenna input
AUX input (Stereo)
Use the mini-plug which is stereo type
and does not have any resistance.
To connect the Kenwood navigation system, consult your
navigation manual.
To front left speaker
To front right speaker
To rear left speaker
To rear right speaker
Ignition key
switch
Car fuse box
(Main fuse)
Battery
– +
27
|
English