Table of Contents
Advertisement
7:
SYNC
2:
RC
6:
TEST
13, 14
READY
FC
AUDIO
HENSEL-VISIT International GmbH
With the transmitter available as accessory, flashes can
be triggered and in addition features for flash power
and modeling light adjustment are offered.
For operation with Expert / Integra Pro Series units the
radio receiver is attached to the sync socket 7 of the
compact flash. The respective Plus versions have a
built-in receiver that needs to be activated by pressing
the RC switch 2.
The radio transmitter is attached to the camera using
the synchronization cable or by mounting it onto the hot
shoe of the camera. Three channels can be selected.
The selected channel of the transmitter and receiver
must correspond to each other. Flashes can be
triggered by pressing the TEST button or by releasing
the camera shutter.
For a detailed description of the radio control system,
please refer to chapter 9.
Test Flash
By pressing the button 6 test flashes can be released.
Flash power control
The desired flash power can be set in 1/10 f-stops over
a range of 6 f using power control switch 13. The
setting is shown on the LED display 14 presenting
values ranging from 5.0 (minimal flash power) to 10.0
(maximum flash power).
Flash readiness
Flash readiness of the compact flash unit is shown by
green light of the READY lamp above TEST button 6
modeling lamp turned on when Flash Check mode is
activated (switch 4)
acoustical signal, when AUDIO 3 is switched on.
APD system
In case of reducing the flash power, the stored energy
will be discharged by APD system (Automatic Power
Drop). No flash will be triggered. After switching off, the
compact flash units will be discharged automatically.
User manual // Expert / Integra Pro (Plus)
17
Hide quick links:
Advertisement
Table of Contents
