Table of Contents
Advertisement
19
20
18
17
16, 17
HENSEL-VISIT International GmbH
flash unit is located far enough from inflammable props
to avoid inflaming them.
Take care for sufficient air supply and make sure that
ventilation slots of compact flash units are kept free. Do
not operate flash units unattended. The modeling light
should never be used for lighting up the studio but only
as assistance when focusing or determing the light
guiding and shadow details of the flash.
Acclimatizing
When moving the flash unit from one climatic zone to
the next, the appliance should stand in the room, in
which it will be operated, for some time before starting it
up. This prevents possible surface leakage currents
due to con-densing water.
Positioning
Expert / Integra Pro compact flash units come with a
tilting head. The unit can be attached to a stand or
pantograph by using one of the two holes and safely
secured by fastening the locking screw 19. The angle of
inclination can be adjusted using the wing nut 20. In the
hole above the wing nut an umbrella can be inserted
and fastened using the clamping screw 18. To hold
even heavy loads it is advisable to find a new optimal
position for the tilting head within the gliding rail. For
doing this, unscrew the Philips screw 17 and slide the
tilting head within the rail until the weight is balanced
and finally tighten the screw. An additional valuable
feature for hand-ling heavy weights is the pre-friction
that ensures a decelerated and smooth movement of
the tilting head. If required, the friction can be varied by
turning the hexagon nut 16 to the left or to the right.
The features 16 and 17 are only available for the
respective Plus versions.
Fixing of the glass dome
Attention:
The glass dome should only be fixed or removed after
having switched the unit off and unplugged from the
mains outlet. Please take care not to damage either the
flash tube or the modeling lamp (danger!).
User manual // Expert / Integra Pro (Plus)
13
Hide quick links:
Advertisement
Table of Contents
