Accessories - Hensel Expert Pro User Manual

User manual // Expert / Integra Pro (Plus)
20, 18
14
The glass dome is fixed by means of the three pre-
mounted springs. For doing this, please tilt the glass
dome slightly and insert it into one of the three springs.
Then press the glass dome gently into the other two
springs until it has completely clicked in. For removing
the glass dome, please tilt it slightly again so that it will
slip out easily of the two fixing springs. Then gently
loose the glass dome from the remaining third spring
and remove it from the fixing device.

Accessories

All HENSEL reflectors and HENSEL softboxes of series
EHT (adapter Ø: 10 cm), accessories included, may be
attached to the Expert / Integra Pro compact flash; also
umbrellas and Softstars.
Assembly of reflectors and softboxes
For fixing reflectors or softboxes to the compact flash
unit, please first of all open the holding clamps. For
doing this, please tension the reflector lever laterally as
far as it will go against the spring tension. While doing
this, the hold-ing clamps will open. Now attach the
accessory part even and precisely to the unit. Please
do not tilt. By releasing the lever, the holding clamps
will enclose the accessory part completely.
For loosening the accessory, please hold tight the
accessory part (Attention - it could be hot!) and tension
the lever again as described above.
In any case please make sure not to damage either the
flash tube or the modeling lamp (danger!).
Assembly of umbrellas and Softstar
An umbrella holder is integrated in the tilting head that
allows for the connections of various umbrellas by
using a strong gripping spring mechanism. The
umbrella is in-serted into the hole above the wing nut
20 and fastened by tightening the clamping screw 18.
HENSEL-VISIT International GmbH