Light Bulb Replacement (If Equipped); Headlight; Taillight; Fuse Replacement (If Equipped) - Ezgo TXT Fleet Electric Owner's Manual

Read all of this manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notices, Cautions, Warnings, and Dangers.

LIGHT BULB REPLACEMENT (IF EQUIPPED)

To reduce the possibility of premature bulb failure, do not touch new bulbs with bare fingers. Use clean, dry

Headlight

To prevent bulb from inadvertantly disconnecting and possibly melting or igniting plastic components, the
locking ring MUST be reinstalled after installation of replacement bulb.
Pull the locking ring straight off the back of the light hous-
ing and allow it to slide down the harness and out of the
way.
Rotate bulb socket a quarter turn counterclockwise to
unlock. Pull out bulb and socket. Insert new bulb and rotate
socket a quarter turn clockwise to secure.
Slide locking ring over new bulb socket and onto back of
light housing.

Taillight

Remove two phillips head screws securing lens and pull
lens out of housing to access the taillight bulb. Remove the
light bulb and install a new bulb, making sure bulb makes
good contact with socket. Replace the lens and reinstall the
phillips head screws.

FUSE REPLACEMENT (IF EQUIPPED)

To replace fuses, raise the seat bottom, the fuse block is located on the
fender liner on the driver side of the vehicle. Pull out old fuse and replace
with a new fuse of the same type and size.
tissue or paper towel to handle the glass portion of the bulb.
MAINTENANCE
Locking
Headlight
Ring
Bulb
Bulb
Rear Fender
Lens
Fuse Block
31