System Connections - Kenwood DPF-J5020 Instruction Manual

System connections

Make connections as shown below.
When connecting the related system components, refer
6
also to the instruction manuals of the related components.
Do not plug in the power lead until all connections are com-
pleted.
Be sure to use this unit placed on a level surface.
75 coaxial cable with RCA PIN (Commercially-available)
Audio cord
1. Connect all cords firmly. If connections are loose, there could be loss of sound or noise produced.
Notes Notes 2. When plugging and unplugging connection cords, be sure to first remove the power cord from the AC outlet. Plugging/unplugging
connection cords without removal of the power cord can cause malfunctions or damage to the unit.
Digital component (MD,DAT, etc.)
DIGITAL INPUT (COAXIAL)
OUTPUT
L
SL16 XS 8
R
SL 16/XS8 switch
7
System control cord
SYSTEM CONTROL
L
R
CD
Digital amplifier or receiver, etc.
Malfunction of microcomputer
If operation is not possible or erroneous display
appears even though all connections have been
made properly, reset the microcomputer refer-
ring to "In case of difficulty".
Optical connection
(Except for the U.S.A., U.S. Military and Canada)
Optical fiber cable (Commercially-available)
DIGITAL
OUT
OPTICAL
SYSTEM DIGITAL
CONTROL OUT
COAXIAL
COAXIAL
DTS Disclaimer clause
When playing DTS-encoded CDs, excessive noise will be exhib-
ited from the analog stereo outputs. To avoid possible damage
to the audio system, the consumer should take proper pre-cau-
tions when the analog stereo outputs of the CD player is con-
nected to an amplification system. To enjoy DTS Digital Sur-
round™ playback, an external 5.1 channel DTS Digital Surround™
decoder system must be connected to the digital output (S/PDIF,
AES/EBU, or TosLink) of the CD player.
System connections
⁄
To OPTICAL terminals
like receiver, MD, DAT,
etc.
Remove the protection cap
when using the DIGITAL
OUT (OPTICAL) jack.
To wall AC
outlet
75 coaxial cable with RCA PIN
(Commercially-available)
DPF-J5020 (En)