Programmed Play (Pgm Mode) - Kenwood DPF-1030 Instruction Manual

Programmed play (PGM mode)

Use the following procedure to program desired tracks in a
desired order. (up to 20 tracks)
14
Preparation
÷ Load a disc in the CD player.
1
Press so that the "PGM" indicator lights.
Do this operation in the stop mode.
0
Go to step 2 within 5 seconds.
2
Program desired tracks.
1
Select the desired track No.
Main unit
(Except for DPF-2030)
(Programming is not
possible during playback)
4 ¢
Go to step 2 within 5 seconds.
2
Set the entry.
0
3
Repeat steps 1 and 2 above.
3
Start playback.
0
To stop playback
0
@
P.MODE
Remote control unit
(Except for DPF-1030)
Press the numeric keys as
shown below....
To enter track No. 15: 05
1 2 3
4 5 6
7 8 9
0 +10
P.MODE
6
7
The figure shows an example for the DPF-2030
: Keys and control used in the operations described on this page.
Lights up.
TRACK
NO.
PGM
0 1
Displays the entered program No.
for a few seconds.
TRACK
NO.
0 2
P _ 0 1
÷ Up to 20 tracks can be programmed. When "FULL" is displayed, no
more tracks can be programmed.
÷ If you make a mistake, press the CLEAR key and enter the track No.
from the beginning.
÷ When the total playing time of the programmed tracks exceeds 100
minutes, the remaining time on the disc will not be displayed any more.
÷ When the 4 or ¢ key is pressed during playback, the track will be
skipped in the direction of the pressed button.
÷ When the 4 key is pressed once during playback, the play position
returns to the beginning of the current track being played.
÷ The programmed contents remain in memory.
7 6
0
4 ¢
1 ¡
Displays the total playing time
of the programmed tracks.
TRACK
NO.
TOTAL TIME
0 2
_
1 6 4 2
: