Normal Play (Track Mode); Playing Tracks In Order From Track No.1 - Kenwood DPF-1030 Instruction Manual

Normal play (TRACK mode)

Use the following procedure to play a CD in the original order
of tracks from track No. 1.
12
Playing tracks in order from track No. 1
1
Press the POWER switch to ON.
0
2
Load a disc.
1
Open the tray.
0
2
Place a disc.
Disc tray
3
Close the tray.
0
3
Start playback.
0
To pause playback
0
÷ Each press pauses and plays the CD alternately.
POWER
- ON – OFF
OPEN/CLOSE
0
Label side
OPEN/CLOSE
0
6
TRACK
6
Lights up.
The figure shows an example for the DPF-2030
: Keys and control used in the operations described on this page.
÷ Playback starts when a disc has been loaded.
÷ Do not touch the played side of disc.
÷ Loading two discs together will cause malfunctioning.
÷ Place the disc properly along the groove on the tray. (If the disc is not
placed horizontally, malfunction will result.)
÷ A single CD (8 cm disc) can also be played.
÷ Ordinary CD single (8 cm) disc adapters sold in audio stores cannot be
used with this unit.
Lights up.
TRACK
TRACK
NO.
0 1
The track Nos. recorded on the CD are displayed.
÷ After a few seconds, play starts from the track No. 1.
TRACK
TRACK
NO.
0 1
Track NO. being played
To stop playback
0
7
0
4
1
1 2 3 4
SINGLE TIME
6 7 8 9
0 0 0
:
Elapsed time of track being played
1 2 3 4
SINGLE TIME
6 7 8 9
0 0 5
:
7
6
¢
¡
5
10
5
10