Programmed Play (Pgm Mode); Start Playback - Kenwood 1050CD Instruction Manual

Programmed play (PGM mode)
The program mode allows you to play desired tracks in the order you want to hear them. A maximum of 32 selections
can be entered in memory.
@ Playing desired tracks in desired order
Preparation: Press the (@] key to set the unit in the stop mode.
r
1 Enter the PGM mode.
Each time the key is pressed,
the setting changes
pope indicator fights up
Go to step 2 within 8 seconds
2 Program desired tracks in desired order.
@ Select the disc.
or
DIS¢ SKIP
Remote control unit
Main unit (Except for 103CD}
Go to step (2: within 8 seconds.
@® Select the track number.
Remote control unit
3 Start playback.
elf the [ee] is pressed during programmed playback. the track being
played is skipped in the next programmed track.
To check the programmed order
inaicator lights up
cueeK |
= aa
m7
GT P- i2
Display showing program No. 12, DISC 3
track No 7
@Every time the K|key is pressed, the track No. and the order it
was programmed (P-No.} are displayed in the order of programming
eThe previous display will resume in a few seconds
Examples of input
Track No. 11 :
Go to step @ within 8 seconds.
@ Press the P MODE key.
P._MOQDE
oooaolMS P-O1
Track number
To resume normal playback
MODE
The playback in the order of the track Nos. on CD will start after the
track being played.
@ By repeating steps ©, @, and @, up to 32 tracks may be selected.
If "FULL" is displayed, no further programming can be accepted.
elf you made a mistake, press the key and select the
correct track.
To program all tracks on a disc:
@ Select the desired disc.
= Press the key again.
To stop programmed playback
Lights up.
me
P -~ ft
uit
aA
14 10s0cD/104cD/103CD (En)