To Check The Edited Contents; To Clear The Edited Contents; Peak Search - Kenwood DPF-1010 Instruction Manual

To check the edited contents

To clear the edited contents

Press any one of these keys.
P.MODE

Peak search

This function identifies the highest peak level of the entire recording on a CD before recording the CD on the cassette deck.
With this unit, after the peak level of each track recorded on the CD has been searched, the section of the music containing the highest peak level will be
played repeatedly so that the recording level of the cassette deck or MD (analog recording) can be adjusted easily.
This feature is particularly convenient when using a cassette deck with manual recording level adjustment which does not have the automatic recording
level adjustment function.
(This unit cannot perform peak search recording when used with a cassette deck equipped with the peak search function.)
To cancel Peak search:
Press the 7 key.
CHECK
CLEAR
0
PEAK SEARCH
STOP
7
The figure shows an example for the DPF-3010
: Keys and control used in the operations described on this page.
Lights up.
EDIT
P.C.
F I L E
÷ When the CHECK key is pressed, track numbers and remaining time
in the file A are displayed first, then those in the file B.
÷ The "P.C." indicator goes off in a few seconds.
÷ The edited data is cleared entirely.
÷ Press the PEAK SEARCH key.
÷ After a high-speed search of all tracks, the searched peak level section
will be repeated at normal speed.
÷ The peak level is detected by sampling the section which seems to
contain the maximum level in the disc. However, it may happen that
the transient maximum level is not detected. Therefore, it is
recommended to set the recording level by leaving a certain margin
above the detected peak level.
DPF-3010/2010/1010 (En)
7 6
4 ¢
1 ¡
A
5
19