To Check The Edited Contents; Playing Or Recording The Edited Contents; To Clear The Edited Contents; Peak Search - Kenwood DP-4090 Instruction Manual

To check the edited contents

REMOTE CONTROL UNIT
RC-P0505

Playing or recording the edited contents

REMOTE CONTROL UNIT
RC-P0505

To clear the edited contents

Press any one of these keys.
P.MODE
REMOTE CONTROL UNIT
RC-P0505

Peak search

This function identifies the highest peak level of the entire recording on a CD before recording the CD on the cassette deck.
With this unit, after the peak level of each track recorded on the CD has been searched, the section of the music containing the highest peak level will be
played repeatedly so that the recording level of the cassette deck or MD (analog recording) can be adjusted easily.
This feature is particularly convenient when using a cassette deck with manual recording level adjustment which does not have the automatic recording
level adjustment function.
(This unit cannot perform peak search recording when used with a cassette deck equipped with the peak search function.)
CHECK
6
CLEAR
0
PEAK SEARCH
E D I T A 01
÷ When the CHECK key is pressed, track numbers and remaining time
in the file A are displayed first, then those in the file B.
Press the 6 key to start playback according to the edited
content. The playback pauses at the beginning of the track
Note Note
edited for tape side B. Press the 6 key again to continue
playback.
When recording the edited content onto a tape, it is recommended
to use the synchro recording or CCRS recording function of
KENWOOD cassette decks.
÷ Do not adjust the output level from this unit particularly during record-
ing.
÷ For details, see the instruction manual of the cassette deck.
÷ The edited data is cleared entirely.
P E A K
÷ After a high-speed search of all tracks, the searched peak level section
will be repeated at normal speed.
÷ The peak level is detected by sampling the section which seems to
contain the maximum level in the disc. However, it may happen that the
transient maximum level is not detected. Therefore, it is recommended
to set the recording level by leaving a certain margin above the detected
peak level.
To cancel Peak search:
Press the 7 key.
DP-5090/4090 (En)
19