Ahost Configuration Strings - Datalogic Hand-held devices II Configuration Manual

A HOST CONFIGURATION STRINGS
In this section we provide a description of how to modify the device configuration
using serial strings sent from the Host.
This method requires either the RS232 or USB-COM interface.
The device configuration can be changed by receiving commands from the Host
through the serial interface. When this method is used, the programming sequence
format is the following:
Command
$+
Enter configuration environment
Example:
BG1 BH0
$+
Each configuration parameter setting removes the condition previously active for that
parameter.
The device buffer can contain about 400 characters. If your
programming string goes over this value, you must split it into separate
groups and send each group after a delay of at least 3 seconds to give
the reader time to empty the buffer and interpret the commands.
NOTE
$-
Character sequence in following tables
Multiple command programming sequence:
AC410132
Matrix 2/5 3 bars: no check digit,
variable length code from 1 to 32 characters
Beeper tone 1
Beeper low intensity
Enter configuration environment
HOST CONFIGURATION STRINGS
CR
Carriage return character (0D Hex.)
Exit and Save configuration
CR
$-
Carriage return character (0D Hex.)
Exit and save new configuration
129