Table of Contents
Advertisement
Chapter 1 Installing Operating System
12. In Paging file size for each drive, enter the value equal or larger than the recommended value for
Initial size, and the value larger than Initial size for Maximum size, and then click Set.
Note the following when specifying a paging file size:
– The boot volume (usually created in drive C:) must have a paging file of its initial size (Total capacity
of physical memory mounted + 400MB or larger) is enough to store the dump file. Specify "Total
capacity of physical memory mounted + 400MB" or larger size.
– Make sure to specify a sufficient paging file size (recommended size: Total capacity of physical
memory mounted * 1.5 or more) for entire system.
– See "System Partition" in Chapter 1 (3.1 Before Starting Setup) for recommended value.
– When DIMM is added, re-specify the paging file according to the increased memory size.
13. Click OK.
14. If a message to restart Windows appears, restart the system according to on-screen message.
Specification of the memory dump settings is now complete.
Express5800/R320c-E4, R320c-M4, R320d-E4, R320d-M4 Installation Guide (Windows)
188
5. Setup for Solving Problems
Advertisement
Table of Contents
