Advertisement
Installation
1
Choose a location to install the
peripheral.
MSR
2
Located the two mounting hole
covers on the back of the monitor
for the chosen location.
3
Peel off hole covers by inserting
a small tool under the lip on the
covers.
4
Fasten the peripheral to the
touchmonitor using the two M3 x
20mm screws included in the kit.
WEBCAM OR MSR
MSR
5
Tilt the monitor back to access
the cable routing cover on the
front of the stand.
6
Remove the cable routing cover
by pushing down on the snap
near the cable opening.
7
Route the periperals' USB cable
through the channel in the stand
and out the back.Then replace
the cable cover.
8
Optional: Install the cable clip
Snap the clip over the cable and
then fasten the clip to the rear
of the monitor using the screw
provided in the kit.
Advertisement
