Test Run; Filter Lamp Reset; Error Code - AirStage UTY-RSKY Installation Manual

(5) Fix the setting by pressing the "
(Data is transferred to the indoor unit).
PROHIBITED
• (-- is displayed,) if not set the
indoor unit.
• Set again as per procedures
(3)-(5) above.
Completion of address setting mode
(6) Function setting mode is released and returns to normal indicator if the
" ▲" button, " ▼" button and "
5 seconds simultaneously.
* Function setting mode is released automatically if no key is pressed
for 60 seconds even the above buttons are not pressed.
(Switch to Function setting mode as per procedure (1) above.)
(7) After completing the FUNCTION SETTING, be sure to turn off the
power and turn it on again.

10. TEST RUN

E T H O D S
(1) If the operation lamp is on, press the "
(2) Press the " " button and the " ▼" button at the same time for
more than 2 seconds to start the test run.
The operation lamp will light up and "
temperature indicator.
(3) To stop the test run, press the "
* The " ▲" button or " ▼" button do not function. However, the other
buttons can be used to change the settings.
* Test run is used for constrained operation of the outdoor unit.
Note:
When " " is indicated on temperature indicator, it means under maintenance.
Indoor unit cannot be operated.
" button.
GOOD
When set properly in the indoor
unit.
" button are pressed for more than
Normal mode indicator
" button to turn it off.
" will be displayed on the set
" button.

11. FILTER LAMP RESET

Some indoor unit models are equipped with a fi lter lamp in the indoor unit
display to indicate when it is time to clean the air fi lters.
Press the " " button for 2 seconds or more. The indoor unit fi lter lamp will
go off and the fi lter indicator will disappear.

12. ERROR CODE

If there is a problem with the air conditioner, "
If an error occurs, it appears automatically on the display as shown below.
Error code
Faulty unit No.
(0-15, C0)
If " " is displayed, immediately contact authorized service personnel.
Do not used the operation below if an error has occurred.
• When 0-15 is indicated on the Faulty unit No., error has occurred at the
indoor unit. Refer to the indoor unit installation manual.
Faulty unit No. Error code
" will be displayed.
Contents
Indoor unit ↔ remote controller
communication error
Incompatible indoor unit is con-
nected
En-8