Cleaning
Filter Locations
A. Rear grille
C.
B. Release tab
D. HEPA filters
1. Press POWER to turn off the air purifier.
2. Unplug air purifier or disconnect power.
3. Press the release tab on the
air
purifier.Gently
pull the rear grille
away from the
unit
and remove.
4. Remove both HEPA filters
filter and
set
aside. Do not try to wash
and reuse either the HEPA filters or the
pre-filter.
5. Clean the air purifier with a soft, damp
cloth.
6. Gently wash the rear grille in soapy
water.
NOTE: The grille
is
7. Insert the 2 HEPA filters
purifier. Insert the pre-filter under
tabs on the rear grille. See the
Replacement" section.
8. Place the tabs on the bottom of the rear
grille into the slots in the air purifier.
Gently
close the grille until the grille
locks into place.
9. Plug in
air
purifier or reconnect power.
10. Press POWER to turn on the air purifier.
AIR PURIFIER CARE
NOTE: The pre-filter and HEPA filter LEDs
will c::hange
the fil t ers. For the most efficient operation of
the air purifier, under normal conditions it is
recommended that
every 3
year. See "Replacement
"Assistance
1. Press POWER to turn off the air purifier.
2.
3.
4. Remove and replace
5. Place the tabs on the bottom of the rear
Pre-filter
6. Plug in air purifier or reconnect power.
7. Press POWER to turn on the air purifier.
rear
of the
8. To reset the HEPA filter status, press the
and
the pre-
9. To reset the pre-filter
not dishwasher safe.
into
the air
the
"Fil t er
-----------------=-
Fil
lrtceN e 1
tc1 JP
to
red when it is time to replace
you
replace the pre-filter
months
and the HEPA filter every
Fil t ers"
or Service" section.
Unplug
air purifier or disconnect power.
Press the
release tab on the rear of the
air purifier. Gently pull
the
away
from
the unit and
the
Install
the
new HEPA filters in the same
direction shown by the arrow located on
the
filter frame. Install the new pre-filter
by placing it
under
the tabs on the rear
grille.See the "Filter Locations"
illustration.
NOTE:
Do
not try to wash and reuse
either
the
HEPA filters
or
grille
into
the
slots
in the air purifier.
Gently close the grille until the grille
locks into place.
HEPA
Filter
Reset button and hold for
5
seconds.
The HEPA filter timer will
reset.
status,
Pre-Filter Reset button and hold for
5 seconds. The pre-filter timer will reset.
NOTES:
• Pressing the filter reset buttons
before either filter
LED
red will not reset the filter timer.
• Use of
a
non-Whirlpool filter or
failure to replace
the filter
will invalidate this warranty.
in
the
rear grille
remove.
indicated filter.
the pre-filter.
press the
changes to
regularly
7
Need help?
Do you have a question about the WHISPURE APT40010R and is the answer not in the manual?