Location Requirements; Requirements; Air Purifier; Some Models) - Whirlpool WHISPURE APT40010R Use & Care Manual

INSTAILATION

REQUIREMENTS

.slectrical Hequieements
Electrical Connection
• To properly install your air purifier, plug
the 2 prong power cord
120-volt outlet.
• This appliance has a polarized plug (one
blade is wider than the other). To reduce
the risk of electric shock,
intended to fit in a polarized outlet only
one way. If the plug does not fit fully in
the outlet,reverse the plug. If it still does
not fit, contact a qualified electrician. Do
not attempt to defeat this

Location Requirements

NOTE:
Your model may differ from the one
shown.
A.
(15.2 cm) minimum clearance
6 "
• You will need a level surface at least 6"
(15.2 cm) from heat sources such as
ranges or heaters.
• Do not block air openings or place air
cleaner on a soft surface such as a bed
or sofa.
• Operate indoors only.
4
-------
Staiting/Stt>pping Yow·Air Purifier
NOTE:
record the date of installation on the HEPA
filter.Under normal conditions, the HEPA
filter should be replaced annually, and the
pre-filter should be replaced every
into a grounded
3 months. To remove and replace either
filter, see "Filter Replacement" in "Air Purifier
Care."
This manual covers several different
this plug is
The air purifier you have purchased may
have some or all of the features listed.
NOTE:
shown.
safety feature.
Control Panel
A.
Fan speed button
B. Auto fan speed button
C. Timer plus
D. Dust sensor LED (on

some models)

E. HEPA filter reset
button
F. Power button
Remote control
G.
receiver
1. Plug the 2 prong polarized plug into a
grounded outlet.
2.
Press POWER to turn on the air purifier.
All segments of the Timer Display will
light, the fan speed will be set to Low
speed, and the green LED indicator light
will
- - -- - -- - - - - - --- - --
A I R P U R I F I E R U S
Before operating the air purifier,
Your model may differ from the one
H. Timer
button
I. Pre-filter reset
"+" button
button
J. VOC sensor LED
K. Timer minus
button
L. Sleep mode
button
Usir1 g the Cont:! :' a ne!
turn
on.
-------
E
models.
on/ off
"- "