Sleep Mode
To activate sleep mode, press SLEEP
Low (L) fan speed with all control panel lights dimmed. To exit,
press SLEEP
, SPEED
Control Lock
The Control Lock locks the controls to prevent unintended
1. Press and hold SLEEP
Lock indicator light will turn "ON". No selection can be made.
2. Press and hold again SLEEP
Control Lock indicator light will turn "OFF". Settings can now
be changed and the unit turned "ON" or "OFF".
Filter Status Lights
AIR PURIFIER CARE
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
Cleaning
1. Press POWER
to turn "OFF"
2.
3.
Gently pull the rear grille away from the unit and remove.
4.
5.
6. Gently wash the rear grille in soapy water.
NOTE: The grille is not dishwasher safe.
7.
8. Place the bottom tabs on the rear grille into the bottom slots
locks into the place.
9.
10.
4
. Sleep mode runs on
, or POWER
.
for 3 seconds to lock. The Control
for 3 seconds to unlock. The
Filter Replacement
NOTE:
P
"Replacement Filters" in the "Assistance or Service" section.
D
E
A. Mainframe assembly
B. Controls
Replace the filter regularly. The use of a non Whirlpool filter may
invalidate the warranty.
1. Press POWER
2.
3.
Gently pull the rear grille away from the unit and remove.
4.
NOTE:
5. Place the bottom tabs on the rear grille into the bottom slots
locks into the place.
6.
7. Press POWER
8. Press either the PRE-FILTER or the HEPA FILTER button
timer.
NOTE:
smoky or dusty environments.
C
B
A
E. Rear grille
for