1. Plug into a grounded 3 prong outlet.
2. Press POWER to start the air purifier. An indicator light will
turn on.
3. Press POWER to stop the air purifier. The indicator light will
turn off.
Fan Speed
Press FAN SPEED until the indicator light comes on for the
desired speed.
Fan Speed
Result
Low
Best product sound
Medium
Slower cleaning power
High
Moderate cleaning power
Turbo
Maximum cleaning power
Sleep Mode
Press SLEEP MODE to set. Sleep mode runs on Low fan speed
for 8 hours and then returns to previously selected setting. To exit
before 8 hours, press SLEEP MODE, FAN SPEED or POWER.
C
A. Release tabs
D. Pre-filter
B. Controls
E. HEPA filter
C. Front grille
Using the Controls
AIR PURIFIER CARE
A
B
A
D
E
F
G
F. Bottom slot
G. Mainframe
assembly
Control Lock
The Control Lock locks the controls to prevent unintended
changing of the settings when the air purifier is on or off.
1. Press and hold SLEEP MODE for 5 seconds to lock. The
Control Lock indicator light will turn on. No selection can be
made.
2. Press SLEEP MODE for 5 seconds to unlock. The Control
Lock indicator light will turn off. Now selections can be made
and the unit can be turned on or off.
Filter Status Lights
The pre-filter and HEPA filter status lights will help you know
when to change your filters. The green status lights will move
from New to Replace at preset intervals. When the red Replace
status light is flashing, replace the filter as indicated. See "Filter
Replacement" in the "Air Purifier Care" section.
Cleaning
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical shock.
1. Press POWER to turn off the air purifier.
2. Unplug air purifier or disconnect power.
3. Place fingers on the front release tabs. Gently push the tabs
in and pull the front grille forward to remove it.
Electrical Shock Hazard
5