Initialize Tab - Sony SNC-CH115 User Manual

1920 × 1440: Image will have an aspect ratio of 4:3, and
an image size up to 1920 × 1440 can be specified for
the video codec.
Notes
• The camera restarts when the Maximum image size is
changed. It takes about 2 minutes.
• The settings below are changed when the Maximum
image size is changed.
– Camera menu-Privacy Masking tab: returns to the
factory setting.
– Camera menu-video codec tab: returns to the factory
setting except:
– Image size of image1: to be 1280 × 720 when set
to 1280 × 720, or 1280 × 1024 when set to
1280 × 1024.
– Frame rate of image1: to be 30 fps when set to
1280 × 720, or 20 fps when set to 1280 × 1024.
– Maximum detection size of motion diction: to be
width of 1280 and height of 720 when set to
1280 × 720, or 1280 and height of 1024 when set
to 1280 × 1024.
• Once the maximum image size has been changed, full
panorama image will not be displayed in the optimum
aspect ratio. To return to the optimum aspect ratio,
capture the full image again in Initialize tab -
Capture full image.
Monitor out (SNC-CH115/CH120/CH160/
CH220/CH260/DH120/DH120T/DH160/
DH220/DH220T/DH260/EB520/EM520/
EM521)
You can configure the output setting for the monitor
output terminal of this unit. Select On to output an
NTSC or PAL signal.
Notes
• Monitor out is used when you install this unit to
adjust the angle of view, etc. Be sure to set Off and
unplug the AV cable when you do not use this
function.
• Be aware that the system performance may be
influenced, if monitor out is set to on.
• The output signal format is determined according to
the setting of the camera's NTSC/PAL switch.
• Motion detection function is not available when
Monitor out is set to On.
Video out (SNC-ZB550/ZM550/ZM551)
When the network connection change switch is set to
LAN, you can configure the output setting for the
monitor output terminal of this unit. Select On to output
an NTSC or PAL signal.
Note
• The video signal format is determined by the setting of
the camera's "NTSC/PAL Change Switch" setting.
• When Video Output is set to On, the motion
detection function is not available.
OK/Cancel
See "Buttons common to every menu" on page 32.

Initialize Tab

Display sample: SHC-CH120
Reboot
Used when rebooting the camera.
Click Reboot, and the message "This System will be
rebooted. Are you sure?" appears. Click OK to reboot
the camera. It takes about two minutes to restart.
Factory default
Resets the camera to the factory settings.
Retain current network settings
When this item is checked, only the current network
settings will be retained after reset.
Click Factory default, and the message "Setup data will
be initialized. Are you sure?" appears.
When you click OK, the network indicator on the
camera starts to blink. After adjustments of the default
settings have finished, the camera reboots automatically.
Do not turn off the camera until the camera reboots.
Tip
The camera can also be reset to the factory settings by
turning on the power of the camera while pressing the
reset button on the camera. For details, see the supplied
Installation Manual.
Configuring the System — System Menu
37