Usb Cable; Powered Usb Cable - CognitiveTPG A799II User Manual

USB cable

Unlike the other connections, the USB cable may be attached and detached while the system is operating.
To install the USB cable:
1 Open the connector cover at the rear of the printer.
2 Attach the USB cable to the USB connector, shown at the left above (A). Don't plug the USB cable into the cash
drawer connector (B) by mistake! Doing so may damage the printer. The USB symbol should face up when inserted
into the port. Make sure the connection is snug.
3 Route the cable through the strain relief on the connector cover (see the "Cable routing" section which follows on page
21).
4 Connect the cable to the USB port in the host computer. Again, make sure the USB symbol on the connector is face up
when you plug it into the port.
Note: If the printer is configured to use CommClass USB, you must install the CommClass USB driver on the host
computer. The driver is available for download from the website at www.CognitiveTPG.com.

Powered USB cable

Powered USB communication connector panel
Powered USB
connector
1 Be sure the host computer is turned off.
2 Plug the printer end of the USB cable into the USB connector port on the printer.
3 Plug the computer end of the USB cable into the computer.
09/2013
Printer end
of USB cable
A799-2UG0000 Rev. A
Chapter 3: Setting up the Printer
Printer end
of USB cable
Computer end
of USB cable
A799II Two-Color Thermal Receipt Printer: User Guide
19
Computer end
of USB cable