Installing A Wireless Lan Module; Replacing The Ide Hard Drive; Removing The Hard Drive; Installing The Hard Drive - Fujitsu Stylistic ST5100 Series Technical Reference Manual

Tablet pc (windows vista os)

Hide thumbs Also See for Stylistic ST5100 Series:

Table of Contents

Installing a Wireless LAN Module

To install a new Wireless LAN Module, follow the instructions in "Removing a Wireless LAN Module" on page 53, in

reverse order.

The internal IDE hard drive in the Stylistic ST5100 Tablet PC can be removed and replaced, if necessary.

• Do not attempt to disassemble or modify the hard drive.

• Do not remove any labels from the hard drive.

• Hard drive replacement should only be performed at a static-free workstation. Avoid touching

connector pins and circuit boards on the drive or Tablet PC. Electrostatic discharge caused by doing

so can damage sensitive components.

To remove the hard drive from the Tablet PC, reference Figure 6-4.

1. Close all applications and shut down the system completely.

2. Using a Phillips screw driver, remove the four screws in the WLAN/hard drive cover plate (see Figure 6-4 for

location). Slide the cover plate slightly towards the edge of the system to disengage it. Remove the cover.

3. Lift the aluminum case holding the hard drive by the end without the connector until it is at approximately a 45

degree angle from the system.

4. Carefully disconnect the small hard drive connector by pulling it away from the drive. Use care when

disconnecting this connector; it is attached to a delicate flex cable.

Do not pull the tab on the flex cable connector when lifting the drive. Doing so could damage the flex

cable; it is fragile.

5. Lift the drive case out of the system, and slide the drive out of the aluminum case.

6. Once the hard drive has been removed from the Tablet PC, you can install a new hard drive. If you are returning

the hard drive for repair, ensure that the packaging material will protect the drive sufficiently during shipment.

To install the hard drive, follow the steps contained in the section entitled "Removing the Hard Drive" in reverse

order. Use care when installing the drive to prevent damage to the flex cable.

The hard drive is now installed in the Tablet PC.

Replacing the IDE Hard Drive

Table of Contents