Castor Wheels - Invacare SpinX Manual

3a.
3b.
1.
Tools: 5 mm Allen key
x
INVACARE ® SPIN
CAMBER, ADjUSTMENT
A
A

CASTOR WHEELS

A
0
°
3
°
6
°
B
You can mount the rearwheel attachment in two ways.
One for 0° camber and one to obtain 3° camber.
3a. 0° camber
Mount the rearwheel attachment (A) on the inside
of the frame as shown in picure 3a.
3b. 3° camber
Mount the rearwheel attachment (A) on the out-
side of the frame as shown in picure 3b.
When you have found the seat height and seat angle
you are pleased with, it is important for the chair's
propelling ability to control that the angle between the
castor attachment and ground surface is 90°.
1. Adjusting the castor angle.
Loosen the screws (A) and (B) by approximately
2–3 turns. Adjust the castor housing to desired
angle by turning it to the correct jag. Retighten
the screws.
Note! It is possible to have negative adjustment of
the castor housing (-3° and -6°) but this is NOT
recommended!
Check that the castor is securely fitted after
replacement and that the jags lockes into each
other.
Do not loosen screw B more than 5 turns. The
corresponding nut will then come loose and
fall out of the castor housing.
19