Invacare SpinX Manual page 18

1.
A
Tools: 5 mm Allen key
10 mm fixed spanner
2.
A
A
Tools: 5 mm Allen Key
3.
Tools: 5 mm Allen Key
18
Passive rear wheel fixation
By changing the position of the rear wheel fixation you
can alter the seat height of the wheelchair.
1. To alter the height position of the rear wheel
Active rear wheel fixation with drumbrake
By changing the position of the rearwheel on the rear-
wheel attachment you can alter both the seat height
and the manoeuvrability/stability of the wheelchair.
The further forward the rearwheel is positioned, the
more manoeuvrable your chair becomes, but with
reduced stability.
2. To alter the height position of the rearwheel plate,
B
3. To move the rearwheel (either backwards or for-
B
fixation, use an Allen key and a fixed spanner to
remove the screws , washers and nuts. Choose
the new position and fasten the screws again.
Note that the holes (A) are the reference holes
for mounting the fixation correctly/horizontally.
When you have fitted the wheels in the cor-
rect position, it is important that you check
thoroughly that the screws and nuts are
tightened securely. This is important for your
own safety.
Always remember to adjust the brakes, when
the rear wheel position is changed.
use an Allen key to remove the screws (A), choose
the new position and fasten the screws again.
Always remember to adjust the brakes, when
the rearwheel position is changed.
wards) on the rearwheel attachment, first remove
the screws (B), adjust to the required position and
then fasten the screws.
The tip risk increases if the rearwheels are
located in front of the backrest. Use anti-tip
devices.
Always remember to adjust the brakes, when
the rearwheel position is changed.
When you have fitted the wheels in the cor-
rect position, it is important that you check
thoroughly that the nuts and screws are
tightened securely. This is important for your
own safety!
x
INVACARE SPIN
®