Table of Contents
Advertisement
CHANGE
COLLET
AND
O-RING
1. Remove the collet and o-ring from the fitting with a
small screwdriver.
Be careful not to scratch the inter-
nal walls of the collet port. See Figures 27 & 28.
2. Clean collet port, lubricate
and insert the o-ring seal
into the bottom
of the port. See Figures 27 & 28.
3. Push the collet inward until it locks in place. See
Figures 27 & 28.
Push o-ring seal into bottom
of
port then follow with collet.
_/_
_}\ 1
Fitting
/ 0
O-Ring Seal
Collet
Change
collet and o-ring
Figure 27
Collet (depress
to
remove
tubing)
Disconnect
Tubing
Figure 28
CHANGE
BATTERY
When the coin battery is first applied
at initial start up,
the LED indicator
light will flash in a red, amber, green
sequence.
All timers and counters
are reset to zero. In
order to reset the time and gallon count feature, push the
the button
on the PWA and hold until the LED flashes
and release. The battery needs to be replaced
at the time
of filter replacement.
Use only lithium batteries
(CR 2032
or equivalent).
Improper
placement
of battery
could
damage
electronics.
Use care when inserting
the battery
to align it correctly
on PWA with the proper
polarity.
PWA board
Battery/
Reset button
Figure 29
NOTE: It is not recommended
that the RO assembly
be
opened,
if this becomes
necessary,
pay careful attention
to the layout of the parts and the routing
of the tubing.
it will be necessary
to assemble
the unit exactly as
shown for the system to fit together
and function
prop-
erly.
Figure 30
Questions?
Call The Kenmore
Water Line i-800-426-9345
or visit KenmoreWater.com
2i
Advertisement
Table of Contents
