Install Storage Tank - Kenmore Elite ULTRAFILTER 650 625.38556 Owner's Manual

Reverse osmosis system
Table of Contents

Advertisement

INSTALL
REVERSE
OSMOSIS
FILTER
ASSEMBLY
The Reverse Osmosis Filter Assembly
can sit upright
or
lay on it's side. When planning
your installation,
you
need to allow adequate
tubing lengths to be able to
access the back of the Reverse Osmosis
assembly
in
order to change the monitor
battery. See Figure 11.
Figure 11
INSTALL
STORAGE
TANK
1. Apply thread
sealing tape to the threads
on the nipple
at the top of the tank (max. 2 wraps). See Figure 12.
2. Locate the tubing
connector. Tighten the tubing con-
nector with a wrench onto the tank nipple
7-8 turns,
being careful not to cross thread
or overtighten.
See
Figure 12
3. Do not connect the tube at this time. This will occur
later in the assembly.
4. Place the storage tank next to the Reverse Osmosis
Assembly.
The tank can be placed upright
or on its
side.
Jr
/'j
//
//
i i
tubing
connector
tanknipp e
ge tank
Figure 12
Questions?
Call The Kenmore
Water Line 1-800-426-9345
or visit KenmoreWater.com
11

Advertisement

Table of Contents
loading

Table of Contents