Premier reverse osmosis drinking water system (56 pages)
Summary of Contents for Kenmore Elite ULTRAFILTER 650 625.38556
Page 1
OWNER'S MANUAL Reverse Osmosis System MODEL NO. 625.385560 UltraFilter 650 Caution: Read and follow all safety rules and operating instructions before first use of this product. Questions Visit www.KenmoreWater.com or call toll free 1-800-426-9345 (M - F, 7 AM - 8 PM CST) Repair or Parts ? CalJ toll free 1o8004694663 See back cover for other Sears service numbers.
This warranty applies only while this product is in use in the United States or Canada. This warranty gives you specific legal rights, and you may have other rights which vary from state to state. Sears, Roebuck 13" Questions? Call The Kenmore ON REVERSE OSMOSIS and Co., Hoffman Estates, 5-1/2"...
Page 3
Water sys- tems using an inline chlorinator should provide minute chlorine contact time before the RO system. Questions? Call The Kenmore V This system is acceptable concentrations mg/L nitrite in combination from the tified for nitrate/nitrite plies with a pressure...
Reverse Osmosis Assembly Bag Assembly Dropper Saddle Valve Questions? Call The Kenmore list below. Note any Note any damage view and for the part names items. If problems listed require review plumb- Bag Assembly Water Storage...
Page 5
Questions? Call The Kenmore Water System is a The postfilter water pressure remain in the water, after passing through brane, and just before going to the RO faucet. To prevent...
Page 6
All install parts included in package. Outside (Hard Water) Soft, Cold Water Soft, Hot Water Additional Parts required. Questions? Call The Kenmore Typical Under Sink Installation Typical Remote Installation Faucet Outside Faucet (]E tard Water) Sediment Filter Water Air Gap...
Page 7
3. Remove tank and filter from cabinet and set aside. NOTE: You must check and comply with all local plumbing codes. Questions? Call The Kenmore your Drinking Assembly Faucet Test, Purge System the entire manual System can...
Page 8
5. Turn the valve handle all the way in. (clockwise) will pierce the wall of the pipe. See Fig. 5. Questions? Call The Kenmore 6. Do not connect the tubing to the fitting at this time. This will occur later in the installation.
Do not cut too short or the adapter will not make a leak-tight necting fitting. 7. Tighten all connections, but do not over tighten plastic connections. Questions? Call The Kenmore Under Single trap with your unit the sink onto See Figure 6. type installa-...
Page 10
Always be sure to provide an air gap between the hose and the drain point. This will prevent from backing up into the system. Airgaps code in most areas. Questions? Call The Kenmore Faucet Water) Sediment Water Heater Water Softener ""...
3. Do not connect the tube at this time. This will occur later in the assembly. 4. Place the storage tank next to the Reverse Osmosis Assembly. The tank can be placed upright side. Questions? Call The Kenmore FILTER can sit upright assembly on the nipple 7-8 turns, tanknipp e...
See Figure 14. 6. Connect the length of 3/8" black tubing to the 3/8" barb on the bottom of the faucet. See Figure 14. Questions? Call The Kenmore OSMOSIS of the Reverse to choose from: next to the sink faucet will surface.
Use care when inserting to align it correctly on PWA with the proper Figure 15. Questions? Call The Kenmore steps 5 and 6 flow of light that BLUE 3/8" quick connect fitting for the blue tube Filters need...
Page 14
2. Continue holding collet inward ing out. See Figure 20. O-Ring Seal Collet Collet O-Ring Questions? Call The Kenmore THE TUBES push-in Review the follow- the tubes in the next washers for servicing, for heater appearance, on the hanger the o-ring.
Page 15
RED TUBE TO REVERSE OSMOSIS FAUCET The red tube cortnection was completed in the faucet assembly steps. Questions? Call The Kenmore NOTE: Tubing lengths back of the assembly NOTE: Codes in the state of Massachusetts installation the use of saddle...
Page 16
NOTE: The bleach must be removed before drinking the water. See purging the next page. Questions? Call The Kenmore after installation that the person sys- if the tank is not in package to bleach manufacturer's during page.
24 hour purging period is complete. 3. When the purging is finished, your Reverse Osmosis system is ready for use. Questions? Call The Kenmore on the pre- kitchen faucet the following storage tank exist, refer to the...
Page 18
Any remaining tastes and odors are reduced uct water. Clean, high quality drinking at the faucet. Questions? Call The Kenmore SYSTEM Reverse (RO) Drinking has a hand operated water pressure Figure 24. An air-gap is built into the faucet drain water...
Page 19
6. Faucet is activated. 7. Processed water leaves the storage tank and flows to the post filter filtered to ensure fresh taste. 8. Water flows to the Reverse Osmosis Questions? Call The Kenmore PRODUCT WATER FAUCET PRODUCT WATER drain flow...
7. Remove and replace the timer battery. See Figure 29. 8. Turn on the water supply to the RO system. 9. Purge the Reverse Osmosis membrane page 17 for instructions. Questions? Call The Kenmore Cover of prod- sediment car- replace the prefilter...
Page 21
Questions? Call The Kenmore Push o-ring seal into bottom port then follow with collet. at initial start up, PWA board at the time...
Page 22
Replacement specifications, as defined by the manufacturer, Questions? Call The Kenmore sulfide water _ ... (new membraney 58 and 42 for the specific performance water production, temperature and total dissolved...
Page 23
Questions? Call The Kenrnore Water Line 1=800=426=9345 or visit KenrnoreWater.corn...
Page 24
Cause: Missing flow control insert in red drain tube [Correction: or its corresponding port. Questions? Call The Kenmore Correction: If the water supply contains more than 2.0 ppm of chlorine, addi- tional filtering of the water supply to the Reverse Osmosis is needed.
Page 25
Cause: Tubing not pushed in all the way. Cause: Tubing nicked. Cause: Outer tubing surface finish not smooth. Questions? Call The Kenmore i!!!i!!!iiiii!!!i!iii!i i!i!! i i !! Inspect and eliminate restriction or plug. Refer to installation instructions for proper drain connection. See page 9.
Page 27
These o-rings and cottets are for replacement Not included. Tubing lengths for remote installations, direct replacement for colored lengths of tubing. Not illustrated. Questions? Call The Kenmore Description Screw (6 req'd) Washer (4 req'd) Automatic Shut Off Cover Check Valve...
Page 28
iiiiiiiiiiiiiiiiiiiiiiiiiiiiii!_ iiiiiiiiiiiiiiiiiiii For expert troubleshooting iiiiiiiiiiiiiiiiiiii iiiiiiiiiiiiiiiiiiii iiiiiiiiiiiiiiiiiiii iiiiiiiiiiiiiiiiiiii iiiiiiiiiiiiiiiiiiii iiiiiiiiiiiiiiiiiiii For repair - in your home - of all major brand appliances, iiiiiiiiiiiiiiiiiiii lawn and garden equipment, iiiiiiiiiiiiiiiiiiii no matter iiiiiiiiiiiiiiiiiiii For the replacement iiiiiiiiiiiiiiiiiiii owner's manuals that you need to do-it-yourself. iiiiiiiiiiiiiiiiiiii iiiiiiiiiiiiiiiiiiii For Sears professional...