SELECT
LOCATION
OF REVERSE
OSMOSIS
FAUCET
MOUNTING
HOLE
You will need to select the location
of the Reverse
Osmosis Faucet. You have three options
to choose from:
faucet
• Use the existing
sink top hole for the spray hose or
soap dispenser
(Must be 1-1/4" in diameter)
Drill a new hole in the sink
Drill a new hole in the countertop
next to the sink
.
2.
3.
4.
Determine
where you are going to install your Reverse
Osmosis
Faucet.
Check to ensure the Reverse Osmosis
faucet will
mount flat against the mounting
surface.
Visually review the routing
of the tubes from the
Reverse Osmosis
filter assembly
to the faucet. Check
to ensure
there is adequate
tube routing
space
between
the faucet and filter assembly.
if drilling is needed,
drill a 1-1/4" diameter
hole in the
mounting
surface.
IMPORTANT."
Drilling holes into countertops
and
sinks should only be performed
by a qualified
installer
who is certified for drilling
such materials.
Drilling
of
surfaces
made of stone or solid surface materials
such
as granite, marble,
Corian _M or other plastic resin prod-
ucts or sinks made of porcelain
and stainless
steel may
cause permanent,
irreparable
damage to the sink or
countertop
surface.
1/4 turn to connect
faucet base
/q__
_faucet
base
screw
'
_'/"
_ _
__
_
rubber
washer
toggle bolt _
_
r ,_'_-_-_
_/_
_ndecti_l
_lect r°nics
hole in sink or__4_
countertop
i
,
3/8" BLACK tubing-_"_/J
k k_k_"_'_l/4"
RED tubing
3/8" BLUE tubing_
/
\'
\
INSTALL
REVERSE
OSMOSIS
FAUCET
1. Locate and organize
your RO faucet install parts. Refer
to Figure 13.
2. Mount faucet base to sink hole until the faucet base is
square
against the sink surface. The rubber
washer
should be between
the sink surface and the faucet
base.
3. Tighten the toggle bolts until the base is firmly mount-
ed to the sink surface. Do not overtighten.
4. Feed a length of 3/8" blue tubing up through
the hole
and connect to the 3/8" quick connect fitting on the
bottom
of the faucet. See Figure 14.
5. Feed a length of 1/4" red tubing up through
the hole
and connect to the 1/4" barb on the bottom
of the
faucet. See Figure 14.
6. Connect
the length of 3/8" black tubing to the 3/8"
barb on the bottom
of the faucet. See Figure 14.
Figure 13
Questions?
Call The Kenmore
Water Line 1-800-426-9345
or visit KenmoreWater.com
12