Bunn Dual Operating & Service Manual page 5

Hide thumbs Also See for Dual:

Table of Contents

INITIAL SET-UP (cont.)

Models with electronic control assemblies:

Place the tank heater switch at the top of the control assembly in the "ON" position and replace the front panel.

Models with electro/mechanical thermostats:

Rotate the control thermostat knob fully clockwise to the "ON" position and replace the front panel.

4. Wait approximately twenty minutes for the water in the tank to heat to the proper temperature.

5. Place an empty server beneath either brew station and the ON/OFF switch in the upper ("ON") position.

6. Triple-set Timers only: Place the brew station Selector switch in the 1

7. (A) Initiate a brew cycle; after water has stopped flowing from the funnel, place the ON/OFF switch in the lower

("OFF") position and check the water volume in the server. It should be 192 ounces (5.7 L) for 1 1/2 gallons.

If not, adjust the timer as required. Refer to Adjusting Brew Volumes

NOTE: Each batch setting must be adjusted individually, if they are not correct. Volumes are as follows:

1 gallon - 128 ounces (3.8L)

.5 gallon - 64 ounces (1.9L)

(B) If necessary adjust the needle valve to achieve desired water volume to be bypassed around the coffee filter

in the funnel.

NOTE: To increase the water bypass turn the needle valve counterclockwise, to decrease the water bypass turn

the needle valve clockwise. An adjustment of the needle valve will require a timer adjustment for volume. To

determine how many turns must be performed to achieve the desired volume, use the chart below.

MECHANICAL BYPASS WITH ADJUSTABLE NEEDLE VALVE

BYPASS PERCENTAGE VS NUMBER OF FULL TURNS FROM

NOTE: The factory bypass is set at 20%

REFERENCE CHART

MAXIMUM CLOCKWISE POSITION

SINGLE & DUAL BREWERS

NUMBER OF FULL TURNS

Page 5

⁄

gallon position.

27040 011904

Table of Contents

Show Quick Links

Table of Contents

Dual dual010000