Table of Contents
Advertisement
Cut off the power from the camera. Poke a straightened paperclip into the factory reset
switch hole. Turn on the power while holding the reset switch. Release the switch in about
5 seconds after the Power LED blinks. The camera resets to factory defaults and restarts
after completing the factory reset.
You can perform a factory reset while the camera is turned on by poking a straightened
paperclip into the factory reset switch hole and releasing the reset switch. A factory reset
also can be performed remotely by running the INIT program. The camera restarts after
completing the factory reset. Refer to the INIT User's Manual for details on remote factory
resetting.
2.5 Installation
A lens is not supplied with the camera. Ask your dealer or distributor about purchasing one.
The camera supports manual iris and the DC-type auto-iris lenses, and it accepts CS- and
C-mount lenses.
NOTES:
A mega-pixel lens is recommended for the best image resolution.
Video-type auto-iris lenses are not supported.
Use a lens that weighs less than 1.0 lbs. (450g). If the lens weighs too much, the camera
might become unstable.
Manual Iris Lens
1. Remove the protective cover from the camera.
2. Mount the lens on the camera by turning the lens clockwise.
3. Turn the iris ring on the lens to the open position and adjust the iris properly.
DC-Type Auto Iris Lens
1. If necessary, solder the lens control wires to the connector socket supplied with the lens.
NOTE: Please refer to the lens manufacturer's manual for soldering the lens control wires.
Network Camera
7
Advertisement
Table of Contents
