FLIR FC-Series S Installation Manual page 16

Fc-series s
Hide thumbs Also See for FC-Series S:
Table of Contents

Advertisement

1
FC-Series S Camera Installation
Step 4
Step 5
Step 6
Step 7
Step 8
Step 9
Step 10
Step 11
Caution!
When replacing the cover, make sure the ground wire between the cover and the camera body is
completely inside the o-ring groove. If the wire is pinched between the cover and the base, the
camera will not be sealed against water ingress and could be damaged.
Step 12
427-0073-11-12, version 100
Install the wall mount (PN 4129742) to the wall and
pull the cable(s) through the mount. Cut a small
cross-slit in the black mount gasket and push the
cable(s) through the gasket. Pull the cable(s)
through the opening in the bottom of the camera. A
single Ethernet/PoE cable is shown in the images.
Secure the camera to the mount using four M5 x
0.8 threaded fasteners to the bottom of the camera.
Use Loctite 222 low strength thread locker for the
mount fasteners.
As needed, clean the o-ring and the o-ring groove
in the bottom of the camera using isopropyl alcohol
and press the o-ring into its groove.
For each cable, punch hole in the center of a gland
seal from the top using the 3 mm hex key. Insert the
cable from the bottom though the hole.
Place the gland plate back into position and tighten
the four 3 mm captive screws using a torque value
of 1.8 n-m (16.0 in-lbs).
Check the length of each cable to ensure an
appropriate bend radius and terminate the cable.
Push the cable back through the gland seal so that
the seal is extended down not up, as shown in the
illustration below.
Connect the cables as indicated in Figure 1-7 on page 1-7. Ensure that any ground wire
that was removed during installation is reconnected. Replace the cover and tighten the four
3 mm hex screws to 1.8 n-m (16.0 in-lbs).
Using the hex key that is included with the concealed cable mount, loosen the ball joint on
the bottom of the mount, position the camera as required, and then re-tighten the ball joint.
Wrong
Correct
January 2013
Mount Gasket
Figure 1-15: Camera Mount
Figure 1-16: Cable through Seal Plate
1-12

Advertisement

Table of Contents
loading

Table of Contents